scupper self bailing deck

[TMcGovern]

Anyone know where I can get a replacement scupper for my 86 v-20 steplift. Self bailing deck, but cracked scupper needs to be replaced. Any help would be appreciated. Docked in Pirates Cove, Manteo NC ???
??? ???

[labii]

What style does the 1986 use ?

[Seakindly]

Welcome Tmcgovern. :)

Search and ye shall find. 8)


http://www.wellcraftv20.com/cgi-bin/yabb/YaBB.cgi?board=General;action=display;num=10638984 81;start=2#2

[keithboyd]

Docked in pirates cove huh? What a nice place!!! The v20 must be the smallest boat there with the same flair as those Carolina boats.

I have a 86 cutty. I replaced my thru hull fittings a couple of years ago becaused they just broke apart when I tugged on them. I can't believe Wellcraft put a plastic thru fitting below the water line. I'm waiting for a set of stainless thru hulls now from Boaters World. The drains inside my cockpit seem to be in fine shape. Maybe I should check on replacing them also.

Did you find something that keeps water from backing back into the cockpit, this is a problem for me. When I asked about that before on this site I got a bunch of comments about drinking less beer and losing weight.

This is a fun site, I think you will enjoy it. It seems most of these guys are from up north. Its good to have a Nags Header on here.

[MikeB]

I replaced my scuppers on my v-20 cc with ball scuppers. Its seems to work much better than the old style. They sucked. Got them at West Marine but I see everyone sells them now. They just screwed right on in the same fashion. Ofcourse mine are above water line scuppers( well supposed to be anyway).

Mike

[Airslot]

If your talking about the thru-floor part, I went to my local plumber supply house and the guy told me I was looking for a "bar stop". It was brass, the right size, and even came with a stopper which I use. Just remember to pull it out when it rains.

Lance

[TMcGovern]

Thanks for all the help.......you folks are very helpful!!!