Pics!

[JeffXJ]

Finally (If this works) here are the pics of my new rowboat!

http://i5.photobucket.com/albums/y197/JeffXJ/DSC00080.jpg

Side view...

http://i5.photobucket.com/albums/y197/JeffXJ/DSC00075.jpg

The Cockpit

http://i5.photobucket.com/albums/y197/JeffXJ/DSC00086.jpg

Transom..... for now boat relies on manpower instead of horsepower....

http://i5.photobucket.com/albums/y197/JeffXJ/DSC00082.jpg

This area concerned me, but I don't think it came out very well


And that is it. I hope you all can see the pics. I'm trying to use MJ's method I read in another thread

[macojoe]

It works!!

And it don't look all that bad!!

[shicks007]

Nice pics Jeff, I'm learning this photobucket stuff too.

[Mac_Attack]

That boat has great potentional. Thanks for the pictures, please keep posting. Bill Mc ;D

[CT_V-20]

Boat looks good for a '71. Are there drains in the motor well for when water comes over the transom? Also, when the time comes, move that transducer to the starboard side a couple feet to a location behind a flat surface so you get quieter water! Nice looking trailer.

[reelapeelin]

Jeff, she's a little dirty, but I gotta tell ya, that boat looks pretty good...no question you got some work ahead, but honestly it's more than I expected from your prior description...when I first got my '74, the motor was too close to the single drain hole in center of splashwell...real PIA...new motor clears that hole and allows qick drainage...when you hang a motor on her MAKE SURE that drain hole is CLEAR...if you redo transom, fill that hole and do one on each side of the mount...and redo as a 25" rather than the 20" it is now...looks like you can HANG ONE and go... 8)...

Study this site and the Gallery...there are some GREAT ideas these guys have come up with...you gonna luv it!... ;D...

[Jester]

Hey Jeff,
She looks great. Lots of potential there for sure.

I'm curious, in the picture where you said "this area concerns me", what were you trying to show in the picture? Are you getting delamination or blisters or something in the glass?

I can't see it.

[JeffXJ]

Hey Jeff,
She looks great. Lots of potential there for sure.

I'm curious, in the picture where you said "this area concerns me", what were you trying to show in the picture? Are you getting delamination or blisters or something in the glass?

I can't see it.

It's actually cracking. I can't tell if it's just the gelcoat or if it's more serious. I noticed the pic didn't come out very good and I'm going to try to take another pic of it in different light to see if I can show it better. As a matter of fact, I think I'll grab the camera right now.....

[JeffXJ]

Lets try these.....

Starboard side bottom of hull

H:\DCIM\100MSDCF\DSC00090

Starboard side Bottom of hull a little futher back

H:\DCIM\100MSDCF\DSC00092

Port side didn't come out very clear, but it's similar to the Starboard side

[JeffXJ]

Opps, lets try this again...

H:\DCIM\100MSDCF\DSC00090


H:\DCIM\100MSDCF\DSC00092

[JeffXJ]

3rd time a charm????


http://i5.photobucket.com/albums/y197/JeffXJ/DSC00090.jpg



http://i5.photobucket.com/albums/y197/JeffXJ/DSC00092.jpg