Log in

View Full Version : OMC Seadrives


handyman_special
02-02-2007, 11:42 PM
I am a newbie here, Just bought a 1987 V-20 and it has a 2.7 liter V6 with the sea drive. What does anyone think of this motor ? and is this a motor that came stock ? pros and cons of this OMC sea drive ?

macojoe
02-03-2007, 12:03 AM
Well if you bought the boat and the motor is running that is a plus!
There are a lot of them around still. The parts are getting hard to come by.
Run the motor as long as you can, with out putting to much money. Then repower. These boats make great conversions for a bracket and a new outboard!!

Welcome to the site!! Were are you located??

Airslot
02-03-2007, 01:01 AM
Well, 2.7 litre has got to be 150 hp or better. Welcome to the site. Lots of fun to be had here. Bear with us, we tend to stray a little off topic in the off season... ;)

Airslot

THEFERMANATOR
02-03-2007, 01:40 AM
The 2.7L is the same as an 86-87 200 or 225 JOHNSON or EVINRUDE outboard as far as the powerhead and lower unit go. They were the small-bore loopers. PArts are easy to come by for the engine, but thats where it ends. They came stock from WELLCRAFT with the 2.7L as an available option.

reelapeelin
02-03-2007, 03:32 AM
I am a newbie here, Just bought a 1987 V-20 and it has a 2.7 liter V6 with the sea drive. What does anyone think of this motor ? and is this a motor that came stock ? pros and cons of this OMC sea drive ?



How does it run?...have you checked power-head compression?...and lower-unit gear oil?...


Can you post any pictures?...bow, transom cockpit, helm, whole boat...

handyman_special
02-03-2007, 10:24 PM
Thank you for the info, will post pics when i figure how, I am here in sunny Flordia, and am glad i found this site Thanks again for the help

macojoe
02-04-2007, 01:58 AM
I see you found it, I was just going to link this over to your question on the other thread!

:)