RODHOLDER GASKETS.

[charlie_the_tuna]

y'know the rubber gasket that goes between the holder and the gunwale?
need that sheet rubber.
where to get?

[reelapeelin]

y'know the rubber gasket that goes between the holder and the gunwale?
need that sheet rubber.
where to get?



How much ya need??...I've got some 1/4" if it'll work for ya, I'll send ya some...I used it between fiberglass and VHF antenna base... :D ...yer welcomed to this I've got, but if it's too thick, just bed those puppies down w/some 4200 fast-cure ;) ...

[Skools Out]

rubber roofing will work go to Lowes and get some of that.

[charlie_the_tuna]

reel, thanks for the offer. 1/4 sounds a bit thick.
think i'll try skools idea.

[macojoe]

4200 on mine no rubber.

[TunaHead]

Hey CTT maybe these will fit:
http://www.westmarine.com/webapp/wcs/stores/servlet/producte/10001/-1/10001/146957/0/0/replacement%20gasket%20for%20flush%20mount%20rod%2 0holder/All_2/mode+matchallpartial/0/0

[Airslot]

GE Silicone II on mine.

[charlie_the_tuna]

thanks tuna, nope.
these have a square base.
i would love to buy new ones but i got 4 matching ones off an old carver.

[reelapeelin]

thanks tuna, nope.
these have a square base.
i would love to buy new ones but i got 4 matching ones off an old carver.



Post us up some pix on those rod-holders ;D ...