Center console guys, I need help

[Curapa]

I have lost the diagram that I had drawn with the center console location measurements. Would one of you mind measuring the location of your console relative to the transom?

Greatly appreciated,
Curt

[smokeonthewater]

Well I would measure but I'm 1000 miles from my boat.... I have a casting deck in front and iirc the front of my console is about 18" from it....

Honestly tho, I'd say forget a out how the factory had it and mount it wherever it works best for you.

[Curapa]

Thanks, it's actually not going back in the factory location. I was hoping to get a reference to stock location so I know how far I'm moving it. It will most likely end up about 5-6" forward.

[bradford]

Put that thing where it "looks" right.

[Curapa]

:beer:

Trust me, I am. Factory isn't an option on this one. With everything out of the boat it's hard to tell what it did, is, going to look like. I am trying to make sure the fuel level sensor hatch well be under the console and its hard to get an idea without some stock measurements to go off of.

[the daydreamer]

just got back in town I will try to go down to the dock and look at mine 1994 v20 center console. tell me me what you need and I will get it for you!

[Curapa]

Daydreamer, I just saw your post.

If you can get me a measurement from the transom to the console that would be greatly appreciated.

Thanks

[the daydreamer]

curt it is 63 in from the rear of the console to the transom. hope this helps :sun:

[ssiredfish]

curt it is 63 in from the rear of the console to the transom. hope this helps :sun:

I got 64 1/2" on mine to start of footrest.....hahahaha

nominal right??? Haha

[smokeonthewater]

sounds like one of you is measuring from the front of the transom and one from the back.......

[ssiredfish]

sounds like one of you is measuring from the front of the transom and one from the back.......

Mines a lil thicker than 1.5":you:

[smokeonthewater]

That's what we all say............