View Full Version : 90's Evinrude 15hp
Curapa
06-16-2012, 08:23 AM
I just picked up a small boat with what I believe is a 90's Evinrude 15. I am trying to troubleshoot what I believe are minor problems.
First, does anyone know how to wire the starter for a key or pushbutton? There are only two wires coming from the motor, a ground and positive. The people that I bought it from always pull started it. I am assuming I am overlooking something.
I am trying to upload a pic from my phone but the images are to large. I will have to resize and upload later.
phatdaddy
06-16-2012, 09:19 AM
if you are talking about the + &- that go to the battery, then you need a remote wiring harness for that particular engine.with out that, you could wire a pushbutton to send 12 volts to the solenoid & spin the starter.
Curapa
06-16-2012, 09:29 AM
The wires I see are the + / - cables from the engine. I have been spinning the starter by putting power to the solenoid but I figured there was some kind of plug in there somewhere to wire in to. The engine does not have the red plug like I am used to.
tsubaki
06-16-2012, 10:50 AM
I'm trying to remember where the button is on that one. My father had one and gave it to my brother.
Can't remember if it's on the end of the throttle handle or on the housing like choke's usually are. Seemed like the kill switch was also a lanyard too. To shut it off push down where the lanyard connected.
tsubaki
06-16-2012, 11:02 AM
Also, hope they insulated the ends of the wire if they didn't use a battery.
Arcing them while running will damage the stuff like the stator, powerpack, etc.
Curapa
06-16-2012, 11:50 AM
Looking at the diagram online, I see the starter button but it does not show where it is mounted. The end of the tiller handle is hollow so it would make sense for it to be there.
tsubaki
06-16-2012, 12:36 PM
Some of those used the end of the tiller handle for an idle adjustment knob.
Curapa
06-16-2012, 01:14 PM
Yeah, this one has the idle adjustment at the end of the tiller. I'm not sure if it works or not, seems to not be engaging in anything.
I did get the motor running today, the cam follower on the carb is broken so I have to give it fuel by hand.
tsubaki
06-16-2012, 01:22 PM
Go ahead and locate the fuse. The ones with the starter usually have one.
Looks like an ATO fuse.
vBulletin® v3.8.2, Copyright ©2000-2025, Jelsoft Enterprises Ltd.