Do you need a windsheild for your V20?

[Franco]

Check out this company

http://www.updplastics.com/index.htm

[BuilderFL]

I've had my windshield and doors fabricated to my specs by him both in Plexiglass and Starboard. A one man small shop in a warehouse space with good work and timely delivery. Prices are fair.

[awthacker]

Hope this doesn't derail from the intent of the thread, but I can't figure out how to remove my windshield. There are four screws on each side along the front, and one on each side in the back corner. These screws all go from top to bottom. I can't find any other screws along the sides - I've looked and felt on the underside behind the cabin carpeting. Is it just a sealant that's holding it in place now? It's still on there pretty good, even after removing the five screws I can find on each side. Thanks.

Aaron

[Franco]

Hope this doesn't derail from the intent of the thread, but I can't figure out how to remove my windshield. There are four screws on each side along the front, and one on each side in the back corner. These screws all go from top to bottom. I can't find any other screws along the sides - I've looked and felt on the underside behind the cabin carpeting. Is it just a sealant that's holding it in place now? It's still on there pretty good, even after removing the five screws I can find on each side. Thanks.

Aaron

They are thru bolted into the raised portion in the cuddy, you have to pull the upholstrey back to access them

[awthacker]

Finally got the windshield off. Mine was screwed from the top down into the raised rail. The screws were just hiding behind a strip of plastic trim.