Would these work?

[overboard]

Wiring is my major down fall when it comes to repairs ir upgrades. Luckily, I have a really good buddy who is an auto/marine wiring god. I want to buy new gauges for the V. My question to you guys is would these work?
http://cgi.ebay.com/ebaymotors/4-Gauges-Faria-for-Johnson-and-Evinrude_W0QQitemZ230290769623QQcmdZViewItem?hash= item230290769623&_trkparms=39%3A1%7C65%3A10%7C240%3A1318&_trksid=p4506.c0.m245
Thanks for the help. Oh yeah, the motor is a 95 225 Evinrude.

[shubey61]

They should work if you have the systems monitor bult into your tach already, i.e. low oil light over heat light etc.

[randlemanboater]

Those look pretty nice, I think I'll bid on em..........just kidding.

[THEFERMANATOR]

You could make em work, but the systems check is for 96+ OMC's. Does your 95 have the red cannon plug, or the multiple plugs? If the single then you don't need a system check guage. Also get a voltmeter instead of a trim guage. You can turnaround and see how the engine is trimmed, but you need to monitor voltage.

[overboard]

Yeah, mine has the red cannon plug, and I was also conserned about the lack of a voltage gauge but the price seemed to be OK. I guess I got about 20 hours to make my mind up.:head:

[reelapeelin]

Yeah, mine has the red cannon plug, and I was also conserned about the lack of a voltage gauge but the price seemed to be OK. I guess I got about 20 hours to make my mind up.:head:


You'll wanna be able to monitor voltage...if yer adding a depth-finder, most these days have ability to show you that, so you may not need a volt gauge...:party:

[parishht]

Personally I think you should look for a panel like this:

http://flypatchfly.com/wp-content/uploads/2007/11/steam-gauges.jpg

[reelapeelin]

Personally I think you should look for a panel like this:

http://flypatchfly.com/wp-content/uploads/2007/11/steam-gauges.jpg


No, that'll never do...where's the fishfinder?...:head:...