Tuna_Man
07-21-2007, 01:24 AM
Hello, I'm new to this forum. A fishing bud from a fishing forum I belong to suggested that I come here to post this boat for sale.
This boat belongs to real good friends that relocated from PNS to Huntsville,AL. The boat is located in PNS. Storage facility (Penton's) on Denver close to Albertsons one block North of Mobile Hi Way.
The boat can be seen anytime they are open. As soon as you drive in it will be right in front of you. Go by and take a look and make an offer. This boat is somewhat of a project boat. Trailer looks real good as far as I remember, but does have flats. PM me and I'll get you their phone number.
If I remember corectly it has a SS prop.
Here is the boat information:
1977 20 1/2 ft. Wellcraft
1986 150hp Evinrude Outboard..it has a bilge pump
The following things were done in April, 2005:
Removed engine from boat; removed old and installed new stainless steel
tilt tube, bushings, trim motor, steering cable, steering link arm, water
pump kit and exhaust seal. ($1337)
We have some invoices and maintenance records going back to 1997.
We have the title.
Pictures can be seen @ http://www.pensacolafishingforum.com/forum/forums/thread-view.asp?tid=30236&posts=15
Thanks,screaming drags and tight lines to one and all.
This boat belongs to real good friends that relocated from PNS to Huntsville,AL. The boat is located in PNS. Storage facility (Penton's) on Denver close to Albertsons one block North of Mobile Hi Way.
The boat can be seen anytime they are open. As soon as you drive in it will be right in front of you. Go by and take a look and make an offer. This boat is somewhat of a project boat. Trailer looks real good as far as I remember, but does have flats. PM me and I'll get you their phone number.
If I remember corectly it has a SS prop.
Here is the boat information:
1977 20 1/2 ft. Wellcraft
1986 150hp Evinrude Outboard..it has a bilge pump
The following things were done in April, 2005:
Removed engine from boat; removed old and installed new stainless steel
tilt tube, bushings, trim motor, steering cable, steering link arm, water
pump kit and exhaust seal. ($1337)
We have some invoices and maintenance records going back to 1997.
We have the title.
Pictures can be seen @ http://www.pensacolafishingforum.com/forum/forums/thread-view.asp?tid=30236&posts=15
Thanks,screaming drags and tight lines to one and all.